So I read that this was an accordian layout.
Who knows about this?
Here is a dampening master in the works!
Here is another low cost idea turned into reality by applying the new possibilities of 3D printing. My next frame will be equipped with these bar posts.
My collected ideas around the vibraphone can be found here:
http://wyndorps.de/E_index.htm
LIVE ON ZOOM! THIS SUNDAY!
www.bit.ly/coffeehouse2
|
|
Due to the Corona problem, I can't get any thin-walled aluminum tube at the moment. Therefore, I have pimped my old and very much used PVC resonance tubes with a new type of flap.
The new flaps are printed from flexible plastic with a hole "too small" by about 0.1 to 0.2 mm. Therefore, they adhere very well to the shaft after sliding on, but can be aligned and positioned as desired.
I also managed to make this solution foldable. Due to the magnetic coupling, the shafts reconnect by themselves after splitting.
|
|
Ok guys,
next tune is Chi Chi by Charlie Parker.
Memorize the melody and the chords.
Post something here where you play the melody and play the chords. It has to be memorized. And you have to post before the class. :-)
If you don't want to do that, then the pop up class is 25 dollars a session. Get it? Do the work and you get in for free :-).
Pop up classes are informal classes to study a tune. If I get a gig, I would move the class or just turn it over to the students to hang and talk.